What a home inspection covers, and what it does not
The legal definition of a home inspection, what a report has to contain, and the separate inspections you may need for pests, mold, radon, sewer lines and insurance.
New buyers often expect an inspector to find everything wrong with a house. In reality a home inspection is a limited visual examination with a defined scope, and knowing the limits helps you decide what else to order.
What the law says
Florida law is a useful example of how states define it. Section 468.8311 of the Florida Statutes defines home inspection services as a limited visual examination of the readily accessible installed systems and components of a home: the structure, electrical system, heating and cooling system, roof covering, plumbing system, interior components, exterior components and site conditions that affect the structure, for the purpose of providing a written professional opinion of the condition of the home. It covers single-family homes, duplexes, triplexes, quadplexes and condominium or cooperative units, not the common areas of shared properties. Other states set their own standards through licensing law and rules. In Oregon, for example, ORS 701.445 requires the Construction Contractors Board to adopt minimum standards of practice for certified inspectors. Either way, the inspection agreement spells out the scope.
What a report must contain
Under section 468.8323 in Florida, the inspector must give the client a written report that identifies the systems and components that are, in the inspector's professional opinion, significantly deficient or near the end of their service lives; explains why they are deficient where that is not obvious; and lists items that were present but not inspected and the reasons they were not. Repair cost estimates are not required. New York’s rules are similar: the report must cover systems that are deficient, not functioning properly or unsafe, and list any major system or component that was not observed, with the reason. Check your state’s rules and the agreement you sign for the equivalent duties.
New York’s standards of practice
New York spells out the scope in detail in its Department of State standards of practice (19 NYCRR Part 197). Inspectors observe and report on site conditions such as grading and drainage next to the foundation, the structure, exterior, roof, plumbing, electrical, heating and air conditioning, interiors, insulation and ventilation, fireplaces and attics. The same rules list what they are not required to do, which is a good map of where a standard inspection stops:
- move furniture or stored items, lift floor coverings, remove wall or ceiling panels, or run any test that could damage what is being checked;
- look at appliances, alarm and security systems, intercoms or lawn irrigation;
- determine whether hazardous substances are present, including asbestos, mold, lead paint, wood-destroying organisms, urea formaldehyde insulation or contaminants in soil, water or air;
- use special instruments such as moisture meters or gas detectors, except where the standards call for them;
- report on code violations, manufacturer recalls or installation to the manufacturer’s instructions;
- inspect condominium common components or evaluate reserve accounts.
An inspector can offer more than the minimum, but anything extra should be written into the agreement.
What “limited visual” means
- The inspector looks at what is readily accessible. Furniture, stored items, locked spaces, snow, unsafe roofs or crawl spaces can prevent access, and the report should say so.
- Inspectors do not typically open walls, dig up pipes, move heavy items or test for hidden defects.
- A report is a snapshot on one day. Weather, occupancy and seasonal use can hide problems, such as a roof leak that only appears in heavy rain.
- In a condominium or co-op, Florida’s definition leaves out the common areas, and New York’s standards do not require inspectors to inspect condominium common components or evaluate reserve accounts. Ask the association what it can tell you about the roof, structure and building systems.
Separate inspections you may need
- Pests and wood-destroying organisms. Handled by licensed pest control or specific inspectors, often required by lenders in some regions.
- Sewer scope. A camera inspection of the sewer line from the house to the street, useful for older homes.
- Radon. Testing measures radon gas levels in the home; it is a separate test. The EPA recommends fixing a home at 4 picocuries per litre (pCi/L) or more, and considering it between 2 and 4 pCi/L.
- Lead-based paint. For most homes built before 1978, federal rules require the seller to give the buyer a 10-day period to arrange a lead inspection or risk assessment before the buyer is bound by the contract, unless both sides agree in writing to a different period or the buyer waives it in writing (40 CFR 745.110). A standard home inspection is not a lead inspection.
- Mold. Mold assessment is a separate licensed service in some states (Florida licenses mold assessors separately under Part XVI of Chapter 468).
- Chimney, pool and septic inspections.
- Insurance inspections. Insurers in some states, including Florida, may ask for wind mitigation or four-point inspections on older homes; ask your insurer what it needs.
- Structural engineer or specialist. If the inspector flags a structural or foundation concern, follow up with a licensed engineer or contractor.
Before the inspection: the agreement
Read the agreement before inspection day. In New York, the inspector must give you a written pre-inspection agreement describing the scope of the service and its cost, with a printed notice that inspectors may only report on readily accessible and observed conditions and may not provide engineering or architectural services. Elsewhere, ask for the same: the scope, exclusions, fee, how and when the report is delivered, and any clause limiting the inspector’s liability. New York requires the written report within five business days of the inspection.
Attend the inspection
Walk through with the inspector if you can. Seeing a problem and hearing it explained helps you judge its seriousness and whether the report wording is alarming or routine.
After the report
Use it to decide whether to proceed, negotiate or walk away. See our guide on how to read a report and negotiate repairs.
General information only, current as of the date above. The information on Home Inspector Check is not a recommendation or a guarantee of anyone's work. A license record shows registration status on the date shown, not workmanship, insurance coverage at the time of your job, or suitability for your project. Confirm license, insurance and permits directly before you hire. Rules and programs change; check the official sources linked in this guide.